Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1285

match extcommunity Use the match extcommunity command to match BGP extended community list attributes. Use the no form of this command to remove the match extcommunity from the configuration and BGP extended community list attribute entry. NOTE: This command is effective only if BGP is running on the router. Syntax match extcommunity standard-list no match extcommunity standard-list • standard-list-A standard list identifier that identifies one or more permit or deny groups of extended communities. The range if from 0-100. Default Configuration BGP extended community list attributes are not matched. Command Mode Route Map Configuration mode User Guidelines The match extcommunity command is used to configure match clauses that use extended community attributes in route maps. All the standard rules of match and set clauses apply to the configuration of extended community attributes. Command History Introduced in version 6.3.0.1 firmware. Example The following example shows that the routes that match extended community list 10 will set the additional route target attribute to 10:10. (R1)(config)# ip extcommunity-list 10 permit rt 1:1 (R1)(config)# route-map SEND_OUT permit 10 (R1)(config-route-map)# match extcommunity 10 (R1)(config-route-map)# set extcommunity rt 10:10 additive Layer 3 Routing Commands 1285