Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1522

Command Mode Route Map mode User Guidelines Use this route map clause to override active routes in the routing table. This command affects all matching packet types and is used if an active route for the next hop exists in the routing table. The next hop IP address must be associated with a directly connected subnet on the router. If no resolvable active interface is present in the route table, the packet is routed using the default routing table. If more than one IP address is specified, the first IP address associated with a link up interface is used to route the packets. Only one of set ip next-hop, set ip default next-hop, or set interface null0 may be specified in a route map. Example console(config-route-map)#set ip next-hop 192.0.2.1 set ip precedence Use this command to set the three IP precedence bits in the IP packet header on ingress. Values 0 through 7 are supported. This precedence value may be used by other QoS services in the network such as weighted fair queuing (WFQ) or weighted random early detection (WRED). Use the no form of this command to remove a set clause from a route map. Syntax set ip precedence 0-7 no set ip precedence • 0-Sets the routine precedence. • 1-Sets the priority precedence. • 2-Sets the immediate precedence. • 3-Sets the Flash precedence. • 4-Sets the Flash override precedence. • 5-Sets the critical precedence. • 6-Sets the internetwork control precedence. Layer 3 Routing Commands 1522