Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1399

The output shows when BGP counters were last cleared (using clear ip bgp counters). Clearing counters resets all values in this output to 0 except for the high water mark for the work queues. The first table lists the number of BGP messages of each type that this router has sent and received. Following the table is a maximum send and receive UPDATE message rate. These rates report the busiest one-second interval. The queue statistics table reports information for BGP work queues. Items placed on each of these work queues are as follows: • The Events queue includes most timer events and configuration changes. • The Keepalive Tx queue includes timer events to send a KEEPALIVE message to a peer. The Dec Proc queue includes events that cause the decision process to be run. • The Rx Data queue holds incoming BGP messages. • The RTO Notifications queue includes best route change and next hop resolution change notifications from the routing table. • The MIB Queries queue includes pending SNMP queries for BGP status. Command History Introduced in version 6.2.0.1 firmware. Updated in version 6.3.0.1 firmware. Example console#show ip bgp traffic Time Since Counters Cleared: 55223 Seconds BGP Message Statistics Open Update Notification Recd: 6 11 0 Sent: 8 56 3 Keepalive 7888 8465 Refresh 0 0 Max Received UPDATE rate: 1 pps Max Send UPDATE rate: 5 pps BGP Queue Statistics Current Events 0 Keepalive Tx 0 Dec Proc 0 Rx Data 0 RTO Notifications 0 Max Drops Limit 2 0 800 3 0 128 3 0 133 3 0 500 4 0 1222 Total 7905 8532 Layer 3 Routing Commands 1399