Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 2334

Command History Syntax updated in 6.4 release. traceroute ipv6 Use the traceroute command to discover the routers that packets traverse when traveling to their destination. Syntax traceroute ipv6 ipv6address|hostname [init-ttl initTtl] [max-ttl maxTtl] [max-fail maxFail] [interval interval] [count count] [port port] [size size][source {src-ip-address|vlan vlan-id|loopback loopback-id}] • ipv6address-Valid IPv6 address of the destination host. • hostname-Hostname of the destination host. (Range: 1-256 characters). The command allows spaces in the host name when specified in double quotes. For example, console(config)#snmpserver host "host name" • initTtl-The initial time-to-live (TTL); the maximum number of router hops between the local and remote system (Range: 1-255). the default is 1. • maxTtl-The largest TTL value that can be used (Range:1-255). The default is 30. This must be larger or equal to the value specified in initTtl. • maxFail-Terminate the traceroute after failing to receive a response for this number of consecutive probes (Range: 1-255). • interval-The timeout period. If a response is not received within this period of time, then traceroute considers that probe a failure (printing *) and sends the next probe. If traceroute does receive a response to a probe, then it sends the next probe immediately. (Range: 1-60 seconds). The default is 3. • count-The number of probes to be sent at each TTL level (Range:1- 10). • port-The destination UDP port of the probe. This should be an unused port on the remote destination system (Range: 1-65535). Switch Management Commands 2334