Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 758

Peak Burst Size (PBS) A packet is colored red if it exceeds the PIR, yellow if it exceeds the CIR, but not the PIR, and green if it does not exceed either. A trTCM is useful when a peak rate needs to be enforced separately from a committed rate. The CIR and PIR are measured in Kbps (not pps as indicated in the RFC), the CBS in Kbytes, and the PBS in Kbytes. It is recommended that the CBS and PBS be configured to be larger than the largest expected IP packet. A class command in policy-map mode must be issued for an existing class-map before entering this command. Example console(config-policy-classmap)#police-two-rate 100000000 64 1000000000 32 conform-action set-cos-transmit 7 exceed-action set-prec-transmit 7 violateaction drop policy-map Use the policy-map command in Global Configuration mode to establish a new DiffServ policy or to enter policy map configuration mode. To remove the policy, use the no form of this command. NOTE: This command is not available on the N1500 Series switches. Syntax policy-map policyname [in|out] no policy-map policyname • policyname- Specifies the DiffServ policy name as a unique casesensitive alphanumeric string of characters. (Range: 1-31 alphanumeric characters.) • in-The policy is applied on ingress. Must be specified to create new DiffServ policies. An existing policy can be selected without specifying "in" or "out". • out-The policy is applied on egress. Either "in" or "out" must be specified to create a new DiffServ policy. An existing policy may be selected without the "in" or "out" parameter. Layer 2 Switching Commands 758