Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 256

Table 2-5. Navigating CLI Command Modes (continued) Command Mode Access Method Command Prompt Exit or Access Previous Mode Tunnel From Global Configuration mode, use the interface tunnel command. Or, use the abbreviation interface tu. console(config-tunneltunnel- To exit to Global id)# Configuration mode, use the exit command, or press + to Privileged Exec mode. Loopback From Global console(config- configuration mode, loopbackloopback-id)# use the interface loopback command. Or, use the abbreviation interface lo. To exit to Global Configuration mode, use the exit command, or press + to Privileged Exec mode. Starting the CLI To begin running the CLI, perform the following steps: NOTE: This procedure is for use on the console line only. NOTE: The Easy Setup Wizard may appear if the switch has no user configuration saved. Follow the procedure in the Getting Started Guide to configure the switch using the Easy Setup Wizard. 1 Start the switch and wait until the startup procedure is complete and the User Exec mode is entered. The prompt console> is displayed. 2 Configure the switch and complete any required tasks. 3 When finished, exit the session with the quit or exit command. The switch can be managed over a direct connection to the switch console port or through a Telnet connection. If access is through a Telnet connection, the switch must have a defined IP address, corresponding management access granted, and a connection to the network. Using the CLI 256