Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 2058

command and responds with either a PASS or FAIL response. If approved, the command is executed. Otherwise, the command is denied and an error message is shown to the user. If contact with the authorization method fails, then the next method in the list is attempted. Examples Use the following command to enable TACACS command authorization for telnet. console(config)#line telnet console(config-telnet)# authorization commands mycmdAuthList enable authentication Use the enable authentication command in Line Configuration mode to specify the authentication method list when accessing a higher privilege level from a remote telnet or console. To return to the default specified by the enable authentication command, use the no form of this command. Syntax enable authentication {default | list-name} no enable authentication • default - Uses the default list created with the aaa authentication enable command. • list-name - Uses the indicated list created with the aaa authentication enable command. (Range: 1-12 characters) Default Configuration Uses the default set with the command aaa authentication enable. Command Mode Line Configuration mode User Guidelines Use of the no form of the command does not disable authentication. Instead, it sets the authentication list to the default list (same as enable authentication default). Switch Management Commands 2058