Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1343

Syntax set extcommunity rt value [additive] no set extcommunity rt • value - Specifies the route target extended community value. This value can be entered in one of the following formats: - 16-bit AS number: a 32-bit value (Ex: 64496:11) - 32-bit IPv4 address: a 16-bit value (Ex: 10.1.1.1:22) - 32-bit AS number: a 32-bit value (Ex: 65537:60110) • additive-Adds a route target to the existing route target list without replacing any existing route targets. Default Configuration No RT extended community attributes are set. Command Mode Route Map Configuration mode User Guidelines The route target (RT) extended community attribute is configured with the rt keyword. This attribute is used to identify VRFs that may receive routes that are tagged with the configured route target. Configuring the route target extended attribute with a route allows that route to be placed in the per-site forwarding tables that are used for routing traffic that is received from corresponding sites. Only one route target can be specified in a single set extcommunity rt command. To specify more than one route target, issue the command again with the additive keyword. By default, specifying route targets causes the system to replace existing route targets with the new route targets, unless the additive keyword is used. The use of the additive keyword causes the system to add the new route targets to the existing route target list, but does not replace any existing route targets. Command History Introduced in version 6.3.0.1 firmware. Command updated in version 6.6 firmware. Layer 3 Routing Commands 1343