Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 756

- set-dscp-transmit dscp-val: Remark the DSCP in the packet to dscpval and transmit. (Range 0-63) - set-cos-transmit 802.1p-priority: Remark the 802.1p priority in the packet to 802.1p-priority and transmit. (Range 0-7) - transmit: Transmit the packet unmodified. Default Configuration There no default configuration for this command. Command Modes Policy-Class-Map Configuration mode User Guidelines An srTCM meters a traffic stream and colors packets according to three parameters: Committed Information Rate (CIR), Committed Burst Size (CBS), and Peak Burst Size (PBS). A packet is colored red if it exceeds the CBS and the PBS, yellow if it exceeds the CBS, but not the PBS, and green if it exceeds neither. An srTCM is useful in situations where only the length of the burst, but not the peak rate, determines the service assignment. The CIR is measured in Kbps, the CBS in Kbytes, and the PBS in Kbytes. It is recommended that the CBS and PBS be configured to be larger than the largest expected IP packet. A class command in policy-map mode must be issued for an existing class-map before entering this command. Example console(config-policy-classmap)#police-single-rate 100000000 32 64 conformaction set-cos-transmit 7 exceed-action set-prec-transmit 7 violate-action drop police-two-rate Use the police-two-rate command to implement a two-rate Three Color Market (trTCM) per RFC 2698. NOTE: This command is not available on the N1500 Series switches. Layer 2 Switching Commands 756