Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 2325

stack-port Use the stack-port command in Stack Configuration mode to configure ports as either Stacking ports or as Ethernet ports. NOTE: This command is only valid on the N1100-ON, N1500, N2100-ON, N2200-ON, N3100-ON, and N3200-ON switches. It issues an error response if used on any other switch model. Syntax stack-port {fiftygigabitethernet | fortygigabitethernet | twentyfivegigabitethernet| twentygigabitethernet|tengigabitethernet} unit/slot/port {ethernet | stack [speed { 40g | 21g }]} • speed {40g|21g}-Set the stack port speed. The speed parameter is only available on the Dell EMC Networking N2100/N3100-ON Series switches. Default Configuration By default, Ethernet ports are configured to operate in Ethernet mode. By default, stacking ports are configured to operate in stacking mode. The default port speed on the Dell EMC Networking N2100/N2200/N3000E/N3100 Series stacking ports is 21 Gigabit. The default speed on the Dell EMC Networking N2200 stacking ports is 40 Gigabit. The default speed on the N3200 stacking ports is 2 × 50 Gigabit. Command Mode Stack Configuration mode User Guidelines This command is used to configure Ethernet ports to operate as either stacking or Ethernet ports, or to configure stacking ports to operate as Ethernet ports or stacking ports. A switch family supports only a subset of the syntax options listed above. The stack-port command syntax only allows the supported options for the relevant switch family. Once this command has been issued, the switch must be rebooted in order for the command to take effect. Issuing multiple stack-port commands for a single interface without intervening reboots results in undefined behavior and Switch Management Commands 2325