Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1862

• vrf-name-The name of a VRF. The name must consist of printable ASCII characters other than a question mark and may not have leading or trailing spaces. Spaces may be included if the name is enclosed in quotes. The maximum length of a VRF name is 32 characters. Default Configuration A single global VRF is created when routing is enabled. Command Mode Global Configuration mode User Guidelines This command is only available on the N3000-ON/N3100-ON/N3200-ON switches. Up to 12 VRFs may be configured on the N3000-ON, N3100-ON, and N3200ON. If sufficient resources requested by the VRF instance, such as routes, are not available to create the router instance, a warning is shown and the VRF is not created. The ARP table, among others, is a shared resource and is not allocated or partitioned on a VRF basis. Global commands such as arp cachesize still limit the physical router's shared resources. Example The following example creates two virtual router instances. The routing in the virtual router instance is enabled only when the ip routing command is issued at the virtual router level. (Console) (Config)#ip vrf Red (Console) (Config-vrf-Red)#ip routing (Console) (Config-vrf-Red)#exit (Console) (Config)#ip vrf Blue (Console) (Config-vrf-Blue)#ip routing (Console) (Config-vrf-Blue)#exit ip vrf forwarding This command associates an interface with a VRF instance. Use the no form of the command to associate the interface with the global routing table. Layer 3 Routing Commands 1862