Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 241

CLI Command Modes Since the set of CLI commands is very large, the CLI is structured as a command-tree hierarchy, where related command sets are assigned to command modes for easier access. At each level, only the commands related to that level are available to the user and only those commands are shown in the context sensitive help for that level. In this guide, commands are organized into multiple categories: • Layer 2 Switching commands • Security commands • Data Center Technology commands • Layer 3 Routing commands • Switch Management commands Layer 2 Switching describes the commands used for filtering and forwarding of packets within a VLAN based upon learned MAC addresses. Security describes the commands used to configure switch administrator and end user network access. Layer 3 Routing describes the commands used to forward packets within and across VLANs based upon the IP addresses as well as management of the routing protocols necessary to enable the distribution of routes. Switch Management describes commands used to manage the switch. Commands that cause specific actions to be taken immediately by the system and do not directly affect the system configurations are defined at the top of the command tree. For example, commands for rebooting the system or for downloading or backing up the system configuration files are placed at the top of the hierarchy tree. Commands that result in configuration changes to the switch are grouped in a Global Configuration sub tree. There are levels beneath the Global Configuration mode for further grouping of commands. The system prompt reflects these sub-Configuration modes. All the parameters are provided with reasonable defaults where possible. Using the CLI 241