Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 724

Example The following example uses a simple policer to color TCP packets that exceed an average rate of 1000 Kbps or a burst size of 16 Kbytes as red. Conforming packets (those in CoS queue 1) are pre-colored green prior to metering. After metering, non-conforming packets are colored red. Both green and red packets are transmitted, but may be subject to further color-based action on egress. The example configuration below also shows the configuration of WRED drop thresholds and probabilities for colored traffic. console(config)#class-map match-all class-ipv4 console(config-classmap)#match any console(config-classmap)#exit console(config)#class-map match-all class-cos1 console(config-classmap)#match cos 1 console(config-classmap)#exit console(config)#policy-map color in console(config-policy-map)#class class-ipv4 console(config-policy-classmap)#police-simple 1000 16 conform-action transmit violate-action transmit console(config-policy-classmap)#conform-color class-cos1 console(config-policy-classmap)#exit console(config-policy-map)#exit cos-queue min-bandwidth Use the cos-queue min-bandwidth command in either Global Configuration mode or Interface Configuration mode to specify the minimum transmission bandwidth for each interface queue. To restore the default for each queue's minimum bandwidth value, use the no form of this command. Syntax cos-queue min-bandwidth bw-0 bw-1 ... bw-n no cos-queue min-bandwidth • bw-0 - Specifies the minimum transmission bandwidth guarantee for an interface. You must specify as many bandwidth parameters as there are COS queues (bw-0 through bw-n). (Range: 0-100 in increments of 5) Default Configuration By default, all CoS queues are configured with a 0% minimum bandwidth guarantee. Layer 2 Switching Commands 724