Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 2305

The show switch stack-member-number command also shows details of the switch configuration including the SFS last attempt status for the specified unit. If there is a stack firmware synchronization (SFS) operation in progress, the switch status will show as Updating Code. The show switch command may show an SDM Mismatch value in the Switch Status field. This value indicates that the unit joined the stack, but is running a different SDM template than the management unit. This status should be temporary; the stack unit should automatically reload using the template running on the stack manager. Use the show supported switchtype command to display switch SIDs. Use the show switch stack-ports command to display details regarding stacking links. Use the show slot command to display details regarding slot configuration. Use the show sdm prefer command to display the SDM template configuration. The show switch stack-ports stack-path command is useful in tracking the path a packet may take when traversing stacking links. The command shows active paths only, not those that may be taken after a stack failover or stack reconvergence. The following table describes the fields in the switch stack status example. Unit Switch Management Status Switch Type Preconfigured Model Identifier Description This field displays the unit identifier assigned to the switch. This field indicates whether the switch is the Management Switch, a stack member, or the status is unassigned. This field displays the 32-bit numeric switch type. This field displays the model identifier for this switch. Model Identifier is a 32-character field assigned by Dell to identify the switch. Switch Management Commands 2305