Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 2196

Example The following example attaches a group called user-group to SNMPv3 and assigns to the group the privacy security level and read access rights to a view called user-view. console(config)#snmp-server view user-view iso included console(config)#snmp-server group user-group v3 priv read user-view snmp-server host Use the snmp-server host command in Global Configuration mode to specify the recipient of Simple Network Management Protocol notifications. To remove the specified host, use the no form of this command. This command enters the user into SNMP-host configuration mode. Syntax snmp-server host host-addr [informs [timeout seconds] [retries retries] | traps version {1 | 2 }]] community-string [udp-port port] [filter filtername] no snmp-server host host-addr { traps | informs } • host-addr-Specifies the IP address of the host (targeted recipient) or the name of the host. Both IPv4 and IPv6 addresses are accepted.(Range:1-256 characters) • community-string-Specifies a password-like community string sent with the notification operation. (Range: 1-20 characters). The community-string may include any printable characters except a question mark, a backslash, or an at sign. • traps -Indicates that SNMP traps are sent to this host. • version 1-Indicates that SNMPv1 traps will be used. • version 2-Indicates that SNMPv2 traps will be used. • informs- Indicates that SNMPv2 informs are sent to this host. • seconds-Number of seconds to wait for an acknowledgment before resending informs. The default is 15 seconds. (Range: 1-300.) • retries-Maximum number of times to resend an inform request. The default is 3 attempts. (Range: 1-255) • port-UDP port of the host to use. The default is 162. (Range: 1- 65535.) Switch Management Commands 2196