Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1086

auth-type Use this command to set the accepted authorization types for RADIUS CoA clients. Use the no form of the command to set the authorization type to the default (all). Syntax auth-type { all | any |session-key} no auth-type • all-Selects all CoA client authentication types. All session identification attributes must match for the authentication to succeed. • any-Selects any CoA client authentication type. Any session identification attribute may match for the authentication to succeed. • session-key-Indicates that the session-key (Acct-Session-ID) must match for authentication to succeed. Default Configuration The default is to authenticate with all received session identification parameters. Command Modes Dynamic RADIUS Configuration User Guidelines This command specifies the session identification attributes to validate before acting on a CoA disconnect request. The any/all parameter only applies to the received attributes. It does not mandate which attributes must be contained in the received message. If session-key is specified and the received session ID (Acct-Session-ID) is valid, authentication succeeds even if the session-key does not match. If authentication succeeds and the sessionkey does not match, a response (Disconnect-NAK) will be sent. If authentication does not succeed, no response is sent. This command works in concert with the ignore command. The ignore command refines the all parameter to limit the attribute matching. Security Commands 1086