Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 189

Command Description Modea network area Enables OSPFv2 on an interface and sets its area ROSPF ID if the IP address of an interface is covered by this network command. nsf Enables OSPF graceful restart. ROSPF nsf helper Allow OSPF to act as a helpful neighbor for a restarting router. ROSPF nsf helper strict-lsachecking Set an OSPF helpful neighbor exit helper mode ROSPF whenever a topology change occurs. nsf restart-interval Configures the length of the grace period on the ROSPF restarting router. passive-interface Sets the interface or tunnel as passive. IC passive-interface default Enables the global passive mode by default for all ROSPF interfaces. passive-interface Sets the interface or tunnel as passive. ROSPF redistribute (BGP) Configures OSPF protocol to allow redistribution ROSPF of routes from the specified source protocol/routers. router-id Sets a 4-digit dotted-decimal number uniquely ROSPF identifying the router OSPF ID. router ospf Enters Router OSPF mode. GC show ip ospf Displays information relevant to the OSPF PE router. show ip ospf abr Displays the internal OSPF routing table entries PE to Area Border Routers (ABR). show ip ospf area Displays information about the identified OSPF PE area. show ip ospf asbr Displays the internal OSPF routing table entries PE to Autonomous System Boundary Routes (ASBR). show ip ospf database Displays information about the link state PE database when OSPF is enabled. show ip ospf database database-summary Displays the number of each type of LSA in the PE database for each area and for the router. Dell EMC Networking CLI 189