Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 402

Command Mode Global Configuration, Interface Range and Interface modes User Guidelines Commands under the interface range context are executed independently on each active interface in the range. If the command returns an error on one of the active interfaces, it does not stop executing commands on other active interfaces. If a range of interfaces is specified using the dash notation, the beginning range number (to the left of the hyphen) must be less than or equal to the last number (to the right of the hyphen). Example The following example shows how gigabitethernet ports 5/0/18 to 5/0/20 and 3/0/1 to 3/0/24 are ranged to receive the same command. console(config)# interface range gigabitethernet 5/0/18-20,Gi3/0/1-24 console(config-if-range)# The following example shows how all gigabitethernet ports can be configured at once. console(config)# interface range gigabitethernet all console(config-if-range)# The following examples demonstrate various valid interface ranges: console(config)#interface range gigabitEthernet 1/0/1-20 console(config)#interface range gi1/0/20-48 console(config)#interface range gi1/0/1,gi1/0/48 console(config)#interface range gi2/0/1-10,gi1/0/30 console(config)#interface range gi1/0/1-10,gi1/0/30-48 console(config)#interface range gi1/0/1,te1/1/1 console(config)#interface range gigabitEthernet 1/0/10,te1/1/2 link debounce time Use the link debounce time command to configure the debounce timer for one or multiple interfaces. Use the no form of the command to set the link debounce time to the default (disabled). Layer 2 Switching Commands 402