Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1501

Command Mode Global Configuration mode, Virtual Router Configuration mode, Interface Configuration (VLAN) mode User Guidelines When in virtual router configuration mode, this command operates within the context of the virtual router instance. When in global config mode, the command operates on the global router instance. Virtual Router Configuration mode is only available on the N3000ON/N3100-ON/N3200-ON switches. Example console(config-if-vlan10)#ip redirects ip route Use the ip route command in Global Configuration mode to configure a static route. Use the no form of the command to delete the static route. Syntax ip route [vrf vrf-name] networkaddr {subnetmask | prefix-length} {Null0 | nexthopip | vlan vlan-id [nexthopip]} [preference] [name text][track objectnumber] no ip route [vrf vrf-name] networkaddr {subnetmask | prefix-length} {Null0 | nexthopip | vlan vlan-id [nexthopip]} • vrf-name-The name of the VRF if which the route is to be installed. If no vrf is specified, the route is created in the global routing table. • networkaddr - IP address of destination interface. The address must contain 0's for the address bits corresponding to 0's in the subnetmask. • subnetmask-A 32 bit dotted-quad subnet mask. Enabled bits in the mask indicate the corresponding bits of the network address are significant. Enabled bits in the mask must be contiguous. • prefix-length-A forward slash followed by an integer number ranging from 1-32 (e.g., /24). The integer number indicates the number of significant bits in the address beginning with the leftmost (most significant) bit. Layer 3 Routing Commands 1501