Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1713

Default Configuration Interfaces operate in broadcast mode by default. Command Mode Interface Configuration (VLAN) mode. User Guidelines OSPF treats interfaces as broadcast interfaces by default. Loopback interfaces have a special loopback network type, which cannot be changed. When there are only two routers on the network, OSPF can operate more efficiently by treating the network as a point-to-point network. For point-to-point networks, OSPF does not elect a designated router or generate a network link state advertisement (LSA). Both endpoints of the link must be configured to operate in point-to-point mode. Example The following example shows the options for the ip ospf network command. console(config-if-vlan1)#ip ospf network ? broadcast Set the OSPF network type to Broadcast point-to-point Set the OSPF network type to Point-to-Point ip ospf priority Use the ip ospf priority command in Interface Configuration mode to set the OSPF priority for the specified router interface. Use the no form of the command to return the priority to the default value. Syntax ip ospf priority number-value no ip ospf priority • number-value - Specifies the OSPF priority for the specified router interface. (Range: 0-255) Default Configuration 1 is the default integer value. Layer 3 Routing Commands 1713