Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 2327

The use of 10G stacking links on the N3200-ON is not recommended when 100G uplinks are utilized. If packet loss on the stacking links or stack splits are encountered in this configuration, the stacking links must be upgraded to at least 50G. Command History Added the speed parameter in version 6.5. Syntax updated in firmware release 6.6.1. The 100g/10g syntax was added in firmware release 6.6.2. Example console(config-stack)#stack-port tengigabitethernet 1/0/3 stack stack-port shutdown Use this command to enable or disable the stack port administratively. This command is usually used to diagnose the stack in case any one of the stack ports is exhibiting errors. Syntax stack-port interface-id shutdown no stack-port interface-id shutdown • interface-id-The stacking interface identifier. Default Configuration There no default configuration for this command. Command Modes Stack Configuration mode User Guidelines This command must be used with caution, as disabling a stack port causes the stack to attempt to reconverge. Ensure that the stack is in an active ring topology in order to avoid a stack split. Check the stack ports for errors and also verify that NSF is synced before shutting down any stacking links. Application messages will appear in the logs during stack convergence. Switch Management Commands 2327