Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 530

to participate in the querier election but to stop sending queries as soon as it discovers the presence of another querier in the VLAN. If the switch detects another querier in the VLAN, it will cease sending queries for the querier timeout period. Example The following example configures the snooping querier to participate in the querier election on VLAN 10. console(config)#ip igmp snooping querier election participate 10 ip igmp snooping querier query-interval This command sets the IGMP Querier Query Interval time, which is the amount of time in seconds that the switch waits before sending another periodic query. The no form of this command sets the IGMP Querier Query Interval time to its default value. Syntax ip igmp snooping querier query-interval interval-count no ip igmp snooping querier query-interval • interval-count - Amount of time in seconds that the switch waits before sending another general query. (Range: 1-1800) Default Configuration The query interval default is 60 seconds. Command Mode Global Configuration mode User Guidelines The value of this parameter should be larger than the IGMP Max Response Time value inserted into general query messages by the querier. The default IGMP Max Response Time is defined in RFC 3376 as 10 seconds. Dell EMC Networking queriers use this value when sending general query messages. Use the show ip igmp snooping querier vlan command to display the operational max response time value. Layer 2 Switching Commands 530