Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1204

If the switch is configured in static mode, OpenFlow will remain operationally disabled until a static IPv4 address is configured, the IPv4 address matches exactly an IPv4 address on a VLAN interface, and the VLAN interface is operationally enabled. If the OOB interface is manually selected as the OpenFlow IP address then the Open Flow feature becomes enabled immediately, even if there is no IP address assigned to the service port. If the OOB interface is used to connect to the OpenFlow controllers, the controllers should be on the same subnet as the OOB interface. OpenFlow operates on the stack master only. Flows may not be configured on stack members. Failover to the stack standby unit is not supported. OpenFlow should only be enabled on stand-alone switches and should not be enabled on stacks of switches. This restriction is not enforced. Command History Introduced in version 6.3.0.1 firmware. Example This example configures an interface using VLAN 10 with IPv4 address 1.2.3.1, configures a connection to the controller at IPv4 address 1.2.3.4 TCP port 3435 using SSL security and initiates the connection over the switch front panel interface. console(config)#vlan 10 console(config-vlan10)#interface vlan 10 console(config-if-vlan10)#ip address 1.2.3.1 255.255.0.0 console(config-if-vlan10)#interface gi1/0/1 console(config-if-Gi1/0/1)#switchport mode access console(config-if-Gi1/0/1)#switchport access vlan 10 console(config)#openflow WARNING! OpenFlow does not operate on stack members. Enable OpenFlow on stand-alone switches only. console(config-of-switch)#controller ipv4 1.2.3.4 port 3435 security ssl console(config-of-switch)#mode auto console(config-of-switch)#exit Data Center Technology Commands 1204