Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 494

User Guidelines This command is also used to display the per port configuration and operational status of the green-mode. The status is shown only for the modes supported on the corresponding hardware platform whether enabled or disabled. This command output provides the following information. Term Description Energy Detect Energy-detect admin mode Energy-detect mode is enabled or disabled. Energy-detect operational status Energy detect mode is currently active or inactive. The energy detect mode may be administratively enabled, but the operational status may be inactive. The reasons for the operational status are described below. Reason for Energydetect current operational status The energy detect mode may be administratively enabled, but the operational status may be inactive. The possible reasons are: 1 Port is currently operating in the fiber mode 2 Link is up. If the energy-detect operational status is active, then the reason field shows up as: 1 No energy Detected EEE EEE Admin Mode EEE Admin Mode is enabled or disabled. Rx Low Power Idle This field is incremented each time MAC RX enters LP IDLE Event Count state. Shows the total number of Rx LPI Events since EEE counters are last cleared. Rx Low Power Idle This field indicates duration of Rx LPI state in 10us Duration (μSec) increments. Shows the total duration of Rx LPI since the EEE counters are last cleared. Tx Low Power Idle This field is incremented each time MAC TX enters LP IDLE Event Count state. Shows the total number of Tx LPI Events since EEE counters are last cleared. Layer 2 Switching Commands 494