Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1529

Parameter Description Metric Type The metric type to advertise for redistributed routes of this type. Subnets Whether OSPF redistributes subnets of classful addresses, or only classful prefixes. Dist List A distribute list used to filter routes of this type. Only routes that pass the distribute list are redistributed. Number of Active The number of OSPF areas with at least one interface running Areas on this router. Also broken down by area type. ABR Status The number of OSPF areas with at least one interface running on this router. Also broken down by area type. ASBR Status Whether the router is an autonomous system boundary router. The router is an ASBR if it is redistributing any routes or originating a default route. RIP Section RIP Admin Mode Whether RIP is globally enabled. Split Horizon Mode Whether RIP advertises routes on the interface where they were received. Default Metric The metric assigned to redistributed routes. Default Route Advertise Whether this router is originating a default route. Distance The administrative distance for RIP routes. Interface The interfaces where RIP is enabled and the version sent and accepted on each interface. Example The following shows example CLI display output for the command. console# show ip protocols Routing Protocol BGP Router ID 6.6.6.6 Local AS Number 65001 BGP Admin Mode Enable Maximum Paths Internal 32, External 32 Distance Ext 20 Int 200 Local 200 Address Wildcard Distance Pfx List Layer 3 Routing Commands 1529