Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1042

ipv6:inacl=Named_IPv6_ACL Dynamic ACL Definition This method uses ACL syntax to create a new ingress ACL on the switch: ip:inacl[#number]={extended-access-control-list} ipv6:inacl[#number]={ extended-access-control-list} • The ip token indicates an IPv4 ACL definition follows the equals sign. • The ipv6 token indicates an IPv6 ACL definition follows the equals sign. • #number is the ACL sequence number in decimal format. Range 1- 2147483647. • The tokens ip:inacl and ipv6:inacl are in lower case and are followed by an equals sign with no intervening white space. • extended-access-control-list means an extended IPv4/IPv6 Extended ACL CLI rule definition beginning with the {permit|deny} tokens followed by the protocol {every | eigrp | gre | icmp | igmp | ip | ipinip | ospf | pim | tcp | udp | 0-55} for IPv4 and { every icmpv6| ipv6 | sctp | tcp | udp} for IPv6. Dynamic ACL Example (Extended syntax, that is, ip access-list extended ...) ip:inacl#100=permit ip any 209.165.0.0 0.0.255.255 ip:inacl#110=permit ip any 209.166.0.0 0.0.255.255 ip:inacl#120=permit ip any 209.167.0.0 0.0.255.255 Multiple ip:inacl /ipv6:inacl av-pairs may be present in the RADIUS message. However, only the first definition will be applied for the authentication session. Different sessions, as in the case of the data and voice VLAN authenticating independently, may both have Dynamic ACLs. It is recommended that the DACLs be carefully designed so that they work in harmony, such as, at a minimum, no ACL numbers are duplicated across the DACLs. DACLs are applied at the port level and are capable of affecting any traffic ingressing the port. If there are syntax errors in the received ACLs (other than duplicate rules), the ACL rules are not applied, the RADIUS Access-Accept is treated as an Access-Reject, and a WARN log message or "Interface X/X/X not authorized. Application of downloaded ACL did not complete due to invalid syntax XXXXX" is issued indicating that a received RADIUS rule is misconfigured with invalid syntax Security Commands 1042