Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 285

• queue-id -0-6, where n is number of user configurable queues available for that hardware platform. The queue ID is the internal queue number (traffic class), not the CoS value. Use the show classofservice command to display the assignment of CoS and DSCP values to internal queue numbers. • mirror-Copies the traffic matching this rule to the specified interface. • redirect-Forwards traffic matching this rule to the specified Ethernet interface. • interface-id-An Ethernet interface identifier, for example gi1/0/12. • rate-limit rate burst-size-Specifies the allowed rate of traffic per the configured rate in Kbps and burst-size in kbytes. Rate limits only apply to permit rules. - Rate- The committed rate in kilobits per second - Burst-size-The committed burst size in Kilobytes. Default Configuration An implicit deny all condition is added by the system after the last MAC or IP/IPv6 access group if no route-map is configured on the interface. Command Mode Mac-Access-List Configuration mode User Guidelines The assign-queue and redirect parameters are only valid for permit commands. An implicit deny all condition is added by the system after the last MAC or IP/IPv6 access group if no route-map is configured on the interface. Every permit/deny rule that does not have a rate-limit parameter is assigned a counter. If counter resources become exhausted, a warning is issued and the rule is applied to the hardware without the counter. If a permit|deny clause is entered with the same sequence number as an existing rule, an error is displayed and the existing rule is not updated with the new information. Layer 2 Switching Commands 285