Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 2330

This command may be executed on the stack master or a standalone unit.This command reboots the renumbered switch. After renumbering a switch, it is important to let the master switch synchronize the NSF state before proceeding with additional stack management operations. Use the show nsf command to check the NSF state. If the switch shows Warm Restart Ready as Yes, then the master switch state is synchronized with the standby switch. Failure to observe this caution may result in the master unit spontaneously resetting due to configuration mismatch in order to re-elect a master unit. The range of switch numbers is 1 to maximum stack size. The maximum stack size varies, depending on the switch model. The switch renumber command prompt will display the valid range. Example The following example displays how to reconfigure switch number "1" to an identifier of "2." console(config)#switch 1 renumber 2 telnet Use the telnet command to log into a host that supports Telnet. Syntax telnet {ip-address | hostname} [port] [keyword1......] • ip-address-Valid IPv4 address of the destination host. • hostname-Hostname of the destination host. (Range: 1-256 characters). • port-A decimal TCP port number. • keyword-One or more keywords from the keywords table in the user guidelines (see Keywords Table below). Keywords Table Options /debug /line /localecho Description Enable telnet debugging mode. Enable telnet linemode. Enable telnet localecho. Switch Management Commands 2330