Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 291

remark Use the remark command to add a comment to an ACL rule. Use the no form of the command to remove a comment from an ACL rule. Syntax remark comment no remark comment • comment-Each remark line is limited to 100 characters. The remark may consist of characters in the range A-Z, a-z, 0-9, and special characters like space, hyphen, underscore. The total length of the remark must not exceed 100 characters. Default Configuration No remarks are present by default. Command Mode IPv4 Access-list Configuration mode, IPv6 Access-list Configuration mode, MAC Access-list Configuration mode, ARP Access-list Configuration mode The no form of the command is executed in Global Configuration mode. User Guidelines The administrator can use the remark keyword to add comments to ACL rule entries belonging to an IPv4, IPv6, MAC or ARP ACL. Remarks are associated with the ACL rule that is created immediately after the remarks are created. When the ACL rule is removed, the associated remarks are also deleted. Remarks are shown only in show running-config and are not displayed in show ip access-lists. The no remark command removes the first matching remark from an ACL access-list. Repeated execution of this command with the same remark comment removes the remark from the next ACL rule which associated with the comment (if there is any rule configured with the same comment) or an error message is displayed if there are no matching comments. Layer 2 Switching Commands 291