Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 280

- IPv4 ICMP message types: echo echo-reply host-redirect mobileredirect net-redirect net-unreachable redirect packet-too-big portunreachable source-quench router-solicitation router-advertisement time-exceeded ttl-exceeded unreachable • igmp-type igmp-type-When igmp-type is specified, IP ACL rule matches on the specified IGMP message type (i.e., a number from 0 to 255). • fragments-Specifies the rule matches packets that are non-initial fragments (fragment bit asserted). Not valid for rules that match L4 information such as TCP port number since that information is carried in the initial packet. • log-Specifies that this rule is to be logged if the permit/deny rule has been matched one or more times since the expiry of the last logging interval. The logging interval is 5 minutes. • time-range time-range-name-Allows imposing time limitation on the ACL rule as defined by the parameter time-range-name. (See Time Ranges Commands for more information.) If a time range with the specified name does not exist and the ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is applied immediately. If a time range with specified name exists and the ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is applied when the time-range with specified name becomes active. The ACL rule is removed when the time-range with specified name becomes inactive. • assign-queue queue-id-Specifies the assign-queue, which is the queue identifier to which packets matching this rule are assigned. The queue ID is the internal queue number (traffic class), not the CoS value. Use the show classofservice command to display the assignment of CoS and DSCP values to internal queue numbers. • {mirror | redirect} interface-id-Specifies the mirror or redirect Ethernet interface to which packets matching this rule are copied or forwarded, respectively. • rate-limit rate burst-size-Specifies the allowed rate of traffic as per the configured rate in Kbps, and burst-size in kbytes. Rate limits only apply to permit rules. - Rate - the committed rate in kilobits per second - Burst-size - the committed burst size in Kilobytes. Layer 2 Switching Commands 280