Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1518

Syntax route-map map-tag [permit | deny] [sequence-number] no route-map map-tag [permit | deny] [sequence-number] • map-tag-Text name of the route map. Route maps with the same name are grouped together in order of their sequence numbers. A route map name may be up to 32 characters long and comprised of any printable character except a question mark. Enclose the map-tag in quotes to embed blanks in the name. • permit-(Optional) Permit routes that match all of the match conditions in the route map. • deny-(Optional) Deny routes that match all of the match conditions in the route map. Packets matching deny routes use the routing table. • sequence-number-(Optional) An integer used to order the set of route maps. Route maps are ordered from lowest to greatest sequence number, with lower sequence numbers being considered first. If no sequence number is specified, the system assigns a value ten greater than the last statement in the route map. The range is 0 to 65,535. Default Configuration No route maps are configured by default. If no permit or deny tag is specified, permit is the default. Command Mode Global Configuration mode User Guidelines Apply an ACL rule on the VLAN interface to perform policy based routing based on the VLAN ID as a matching criteria for incoming packets. Packets matching a deny rule or a deny route-map are routed using the routing table. There is no implicit deny all at the end of a route map. Packets not matching any clause are routed using the routing table. Route maps with no set clause are ignored. One use of a route map is to limit the redistribution of routes to a specified range of route prefixes. The redistribution command specifies a route map which refers to a prefix list. Layer 3 Routing Commands 1518