Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 2197

• filtername- A string that is the name of the RFC 2573 Section 6 filter that defines the traps/informs sent to this host. If unspecified, all traps/informs are sent (Range: 1-30 characters.) Use the snmp-server filter command to define a filter. Default Configuration The default configuration is 3 retries, and 15 seconds timeout. No hosts are configured by default. No notifications are sent by default. If you enter this command with no keywords, the default is to send all trap types to the host in SNMPv1 format. No informs are sent to the host. If no version keyword is present, the default is Version 1. Command Mode Global Configuration mode User Guidelines If a DNS host name is entered instead of an IP address, the switch attempts to resolve the host name immediately using DNS. Use the ip domain-lookup command and the ip name-server command to enable resolution of DNS host names. Once resolved, the host name is not resolved again. The hostname parameter may be a fully or partially qualified domain name. A hostname consists of a series of labels separated by periods. Each label may be a maximum of 63 characters in length. The maximum length of the hostname parameter is 256 characters. Refer to RFC 1035 Section 2.3.1 for more information. Command History Added documentation updates in the 6.6.1 firmware release. Example The following example enables SNMP traps for host 192.16.12.143. console(config)# snmp-server host 192.16.12.143 Dell EMC Networking traps version 2 Switch Management Commands 2197