Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.6 - Page 1508

ip route distance Use the ip route distance command in Global Configuration mode to set the default distance (preference) for static routes. Lower route preference values are preferred when determining the best route. The ip route and ip route default commands allow optional setting of the distance of an individual static route. The default distance is used when no distance is specified in these commands. Changing the default distance does not update the distance of existing static routes, even if they were assigned the original default distance. The new default distance are applied to static routes created after invoking the ip route distance command. Use of the optional vrf parameter executes the command within the context of the VRF specific routing table. Syntax ip route distance [vrf vrf-name]integer no ip route distance integer • vrf-name-The name of the VRF associated with the routing table context used by the command. If no vrf is specified, the global routing table context is used. • integer - Specifies the distance (preference) of an individual static route. (Range 1-255) Default Configuration Default value of distance is 1. Command Mode Global Configuration mode User Guidelines Lower route distance values are preferred when determining the best route. The VRF identified in the parameter must have been previously created or an error is returned. Only IPv4 addresses are supported with the vrf parameter. Layer 3 Routing Commands 1508