Dell PowerEdge T300 Hardware Owner's Manual (PDF) - Page 108
Removing the System Fan
View all Dell PowerEdge T300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
3 Route the fan power cable through the adjacent slot in the chassis, and connect the cable to the FAN1 connector on the system board (see Figure 6-1). 4 Replace the RAID battery and battery carrier, if applicable (see "Installing a RAID Battery" on page 101). 5 Close the expansion card cover (see Figure 3-7). 6 Replace the system cover (see "Installing the System Cover" on page 67). Removing the System Fan CAUTION: Only trained service technicians are authorized to remove the system cover and access any components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. 1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and from the peripherals. 2 Remove the system cover (see "Removing the System Cover" on page 66). 3 Remove the processor airflow shroud (see "Removing the Processor Airflow Shroud" on page 70). 4 Disconnect the fan's power cable from the system board (see Figure 6-1). 5 Press and hold the fan release tab, then slide the fan towards the bottom of the chassis and out of the securing slots. 108 Installing System Components