Dell PowerEdge T300 Hardware Owner's Manual (PDF) - Page 99
RAID Battery, Removing a RAID Battery
View all Dell PowerEdge T300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
14 Turn on the system and attached peripherals. 15 Install any device drivers required for the card. See the documentation for the card for information about installing the card's device drivers. RAID Battery The information in this section applies only to systems with the optional battery-cached SAS/RAID controller card. Removing a RAID Battery CAUTION: Only trained service technicians are authorized to remove the system cover and access any components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. 1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and from the peripherals. 2 Remove the system cover (see "Removing the System Cover" on page 66). 3 Disconnect the cable between the RAID battery and the SAS controller card, then remove the battery cable from the battery cable slot in the chassis. 4 Press outward on the battery carrier release tab, then slide the battery carrier up and out of the system. 5 Press outward on the battery carrier retention tabs and remove the RAID battery from the battery carrier. Installing System Components 99