Dell PowerEdge T300 Hardware Owner's Manual (PDF) - Page 121
Installing the Chassis Intrusion Switch, remove the switch and its attached cable from the system.
View all Dell PowerEdge T300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and from the peripherals. 2 Remove the system cover (see "Removing the System Cover" on page 66). 3 Open the expansion card cover (see Figure 3-7). 4 Disconnect the chassis intrusion switch cable from the INTRUSION connector on the system board (see Figure 3-30). 5 Slide the chassis intrusion switch out of the securing bracket notch, then remove the switch and its attached cable from the system. Figure 3-30. Removing and Installing the Chassis Intrusion Switch 2 1 3 1 securing bracket notch 3 INTRUSION connector on system board 2 chassis intrusion switch Installing the Chassis Intrusion Switch 1 Align the chassis intrusion switch with the securing bracket notch (see Figure 3-30). 2 Slide the switch into the securing bracket notch (see Figure 3-30). Installing System Components 121