Dell PowerEdge T300 Hardware Owner's Manual (PDF) - Page 36

Table 1-6. System Messages (continued) Message SATA PORT n drive not found Causes SATA port x was turned on in setup, but a drive was not found. Sector not found Seek error Seek operation failed Faulty hard drive, USB device, or USB medium. Shutdown failure Shutdown test failure. The amount of system memory has changed Memory has been added or removed or a memory module may be faulty. Time-of-day clock Faulty battery or faulty stopped chip. Time-of-day not set Incorrect time or date - please run SETUP settings; faulty system program battery. Timer chip counter Faulty system board. 2 failed Corrective Actions See "Troubleshooting a Hard Drive" on page 153 for the appropriate drive(s) installed in your system. See "Troubleshooting a USB Device" on page 138 or "Troubleshooting a Hard Drive" on page 153 for the appropriate drive(s) installed in your system. See "Troubleshooting System Memory" on page 146. If memory has been added or removed, this message is informative and can be ignored. If memory has not been added or removed, check the SEL to determine if single-bit or multi-bit errors were detected and replace the faulty memory module (see "Troubleshooting System Memory" on page 146). See "Troubleshooting the System Battery" on page 143. Check the time and date settings (see "Using the System Setup Program" on page 41). If the problem persists, replace the system battery (see "System Battery" on page 118). See "Getting Help" on page 175. 36 About Your System