Dell PowerEdge T300 Hardware Owner's Manual (PDF) - Page 86
Installing a Diskette Drive, Installing the Front Bezel
View all Dell PowerEdge T300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
7 Replace the processor airflow shroud (see "Installing the Processor Airflow Shroud" on page 72). 8 Replace the system cover (see "Installing the System Cover" on page 67). 9 Replace the front bezel (see "Installing the Front Bezel" on page 64). Installing a Diskette Drive CAUTION: Only trained service technicians are authorized to remove the system cover and access any components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. 1 Unpack the diskette drive, and prepare it for installation. 2 Remove the front bezel (see "Removing the Front Bezel" on page 63). 3 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and from the peripherals. 4 Remove the system cover (see "Removing the System Cover" on page 66). 5 Remove the processor airflow shroud (see "Removing the Processor Airflow Shroud" on page 70). 6 Remove the existing diskette drive, if applicable (see "Removing the Diskette Drive" on page 84). NOTE: If the drive bay is empty, remove the EMI filler (see "Removing an EMI Filler" on page 68). 7 Attach the four shoulder screws to the diskette drive. See Figure 3-16. NOTE: If the diskette drive you are installing does not have shoulder screws, remove the four shoulder screws from the old drive or the back of the 3.5-inch insert. 86 Installing System Components