Dell PowerEdge T300 Hardware Owner's Manual (PDF) - Page 38
Warning! No micro, Warning: A fatal - raid configuration
View all Dell PowerEdge T300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Table 1-6. System Messages (continued) Message Causes Corrective Actions Warning: A fatal error has caused system reset! Please check the system event log! A fatal system error occurred and caused the system to reboot. Check the SEL for information that was logged during the error. See the applicable troubleshooting section in "Troubleshooting Your System" on page 133 for any faulty components specified in the SEL. Warning! No micro A microcode update code update loaded failed. for processor n Update the BIOS firmware. If the problem persists, see "Getting Help" on page 175. Warning! Detected missing RAID hardware for the embedded RAID subsystem. RAID key or RAID DIMM Information only. missing when system is in RAID mode. Warning! Detected mode change from SCSI to RAID on channel x of the embedded RAID subsystem. The embedded RAID subsystem configuration has changed in System Setup. See "Using the System Setup Program" on page 42. Warning! Detected mode change from RAID to SCSI on channel n of the embedded RAID subsystem. The embedded RAID subsystem configuration has changed in System Setup. See "Using the System Setup Program" on page 42. Warning! Embedded RAID firmware is not present. The embedded RAID firmware does not respond. See "Using the System Setup Program" on page 42. Warning! Embedded RAID error! The embedded RAID See "Using the System Setup firmware responds with an Program" on page 42. error. 38 About Your System