Dell PowerEdge T610 Hardware Owner's Manual - Page 100
Remove the cooling shroud. See Removing the Cooling Shroud
View all Dell PowerEdge T610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
4 Remove the cooling shroud. See "Removing the Cooling Shroud." 5 Disconnect the internal USB module cable from the connector on the system board, and unroute the cable from the cable guides in the chassis. See Figure 3-12. 6 Pull up on the module release tab, and slide the internal USB module to remove it from the slots in the chassis. See Figure 3-12. 7 Install the cooling shroud. See "Installing the Cooling Shroud." 8 Install the expansion card stabilizer. See "Installing the Expansion Card Stabilizer." 9 Close the system. See "Closing the System." 10 Place the system upright and on its feet on a flat, stable surface. 11 Reattach any peripherals, then connect the system to the electrical outlet. 12 Turn on the system and attached peripherals. 100 Installing System Components