Dell PowerEdge T610 Hardware Owner's Manual - Page 89
Installing a Power Supply, On a system with redundant power supplies, verify that both power
View all Dell PowerEdge T610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Figure 3-7. Removing and Installing a Power Supply 1 2 3 1 power-supply handle 3 release latch 2 Velcro strap Installing a Power Supply 1 On a system with redundant power supplies, verify that both power supplies are of the same type and have the same maximum output power. NOTE: The maximum output power of the power supply (listed in watts) is located near the center of the power supply label. 2 Slide the new power supply into the chassis until the power supply is fully seated and the release latch snaps into place. See Figure 3-7. NOTE: If you unlatched the cable management arm in step 2 of the previous procedure, relatch it. For information about the cable management arm, see the system's rack documentation. 3 Connect the power cable to the power supply and plug the cable into a power outlet. Installing System Components 89