Dell PowerEdge T610 Hardware Owner's Manual - Page 42
Embedded NIC, Failure. Verify - uefi
View all Dell PowerEdge T610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Table 1-2. System Messages (continued) Message Causes Corrective Actions Current boot mode is set to UEFI. Please ensure compatible bootable media is available. Use the system setup program to change the boot mode as needed. The system failed to boot Ensure that the boot mode is because UEFI boot mode is set correctly and that the enabled in BIOS and the proper bootable media is boot operating system is non- available. See "Using the UEFI. System Setup Program and UEFI Boot Manager." Decreasing Faulty or improperly installed Reseat the memory modules. available memory memory modules. See "Troubleshooting System Memory." DIMM configuration on each CPU should match. Invalid memory configuration on a dualprocessor system. The memory module configuration for each processor must be identical. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines." Embedded NICx and The OS NIC interface is set Check the system NICy: in BIOS. The Management management software or the OS NIC=, management tools. NIC settings. If a problem is Management indicated, see Shared "Troubleshooting a NIC." NIC= Error 8602 Auxiliary Device Failure. Verify that mouse and keyboard are securely attached to correct connectors. Mouse or keyboard cable is loose or improperly connected. Reseat the mouse or keyboard cable. Defective mouse or keyboard. Ensure that the mouse or keyboard is operational. See "Troubleshooting a USB Device." 42 About Your System