Dell PowerEdge T610 Hardware Owner's Manual - Page 107
Optical and Tape Drives, Removing an Optical or Tape Drive
View all Dell PowerEdge T610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Figure 3-14. Removing and Installing a NIC Hardware Key 1 2 1 NIC hardware key 2 ISCSI_KEY connector 5 Close the system. See "Closing the System." 6 Place the system upright and on its feet on a flat, stable surface. 7 Reattach any peripherals, then connect the system to the electrical outlet. 8 Turn on the system and attached peripherals. Optical and Tape Drives In your system's two 5.25-inch drive bays, you can install one or two optical drives, one half-height tape drive, or one full-height tape drive. Removing an Optical or Tape Drive 1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals. 2 Open the system. See "Opening the System." 3 Remove the expansion card stabilizer. See "Removing the Expansion Card Stabilizer." 4 Remove the cooling shroud. See "Removing the Cooling Shroud." Installing System Components 107