Dell PowerEdge T610 Hardware Owner's Manual - Page 33
Check DIMMs., E2011 Memory - memory configuration
View all Dell PowerEdge T610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Table 1-1. LCD Status Messages (continued) Code Text Causes Corrective Actions E1A1D Control panel USB cable not detected. Check cable. USB cable to the control panel is missing or bad. Reseat the cable. If the problem persists, replace cable. If the problem persists, see "Getting Help." E2010 Memory not No memory was detected detected. in the system. Inspect DIMMs. Install memory or reseat memory modules. See "Installing Memory Modules" or "Troubleshooting System Memory." E2011 Memory Memory detected, but is configuration not configurable. Error failure. Check detected during memory DIMMs. configuration. See "Troubleshooting System Memory." E2012 Memory Memory configured, but is See "Troubleshooting configured but unusable. System Memory." unusable. Check DIMMs. E2013 BIOS unable to The system BIOS failed to See "Troubleshooting shadow memory. copy its flash image into System Memory." Check DIMMs. memory. E2014 CMOS RAM CMOS failure. CMOS failure. Power RAM not functioning cycle AC. properly. Remove AC power to the system for 10 seconds and restart the system. If the problem persists, see "Getting Help." E2015 DMA Controller DMA controller failure. failure. Power cycle AC. Remove AC power to the system for 10 seconds and restart the system. If the problem persists, see "Getting Help." About Your System 33