Dell PowerEdge T610 Hardware Owner's Manual - Page 47

Table 1-2. System Messages (continued) Message Causes Corrective Actions PCIe Training Faulty or improperly installed Reseat the PCIe card in the Error: Expected PCIe card in the specified specified slot number. See Link Width is x, slot. "Troubleshooting Expansion Actual Link Width Cards." If the problem is y. persists, see "Getting Help." Plug & Play Configuration Error Error encountered in initializing PCIe device; faulty system board. Install the NVRAM_CLR jumper in the clear position (pins 1 and 3) and reboot the system. See Figure 6-1 for jumper location. If the problem persists, see "Troubleshooting Expansion Cards." Quad rank DIMM Invalid memory detected after configuration. single rank or dual rank DIMM in socket. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines." Read fault Requested sector not found The operating system cannot Replace the optical medium, read from the hard drive, USB medium, or USB optical drive, or USB device, device. Ensure that the USB the system could not find a cables, SAS/SATA backplane particular sector on the disk, cables, or optical drive cables or the requested sector is are properly connected. See defective. "Troubleshooting a USB Device", "Troubleshooting an Optical Drive", or "Troubleshooting a Hard Drive" for the appropriate drive(s) installed in your system. SATA Port x There is no device connected Information only. device not found to the specified SATA port. About Your System 47