Dell PowerEdge T610 Hardware Owner's Manual - Page 39

Table 1-2. System Messages (continued) Message Causes Corrective Actions Alert! iDRAC6 not The iDRAC6 has hung. responding. Power required may exceed PSU wattage. Alert! Continuing system boot The iDRAC6 was remotely reset while system was booting. After AC recovery, the iDRAC6 takes longer than normal to boot. accepts the risk that system may power down without warning. Remove AC power to the system for 10 seconds and restart the system. Alert! Node Interleaving disabled! Memory configuration does not support Node Interleaving. The memory configuration does not support node interleaving, or the configuration has changed (for example, a memory module has failed) so that node interleaving cannot be supported. The system will still run, but without node interleaving. Ensure that the memory modules are installed in a configuration that supports node interleaving. Check other system messages for additional information for possible causes. For memory configuration information, see "General Memory Module Installation Guidelines." If the problem persists, see "Troubleshooting System Memory." About Your System 39