Dell PowerEdge T610 Hardware Owner's Manual - Page 145
present. See Installing an Optical or Tape Drive.
View all Dell PowerEdge T610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
1 Connect the backplane signal cable to the backplane. See Figure 3-25. 2 Position the SAS backplane so that the metal tabs in the chassis are fully inserted into the securing slots on the backplane. See Figure 3-25. 3 Slide the backplane down until the release pin snaps into place. 4 Reconnect the cables that were previously routed over the notch in the backplane board. a Connect the internal USB module cable to the INT_USB connector on the system board. b Connect the SAS A and SAS B cables to the integrated storage card. See "Installing an Integrated Storage Controller Card." c Connect the power cables to any internal optical or tape drives, if present. See "Installing an Optical or Tape Drive." 5 Reconnect the following cables to the backplane (see Figure 3-25): • SAS A cable • SAS B cable • backplane power cable 6 Install the hard drives in the system. See "Installing a Hot-Swap Hard Drive." NOTE: Reinstall the hard drives in the same drive bays from which they were removed. 7 Install the cooling shroud. See "Installing the Cooling Shroud." 8 Install the expansion card stabilizer. See "Installing the Expansion Card Stabilizer." 9 Close the system. See "Closing the System." 10 Place the system upright and on its feet on a flat, stable surface. 11 Reattach any peripherals, then connect the system to the electrical outlet. 12 Turn on the system and attached peripherals. Installing System Components 145