Dell PowerEdge T610 Hardware Owner's Manual - Page 85
Installing a Hot-Swap Hard Drive, Remove the front bezel. See Removing the Front Bezel
View all Dell PowerEdge T610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
If the drive has been online, the green activity/fault indicator will flash as the drive is powered down. When the drive indicators are off, the drive is ready for removal. 3 Press the button on the front of the drive carrier and open the drive carrier release handle to release the drive. See Figure 3-5. 4 Slide the hard drive out until it is free of the drive bay. 5 Insert a drive blank in the vacated drive bay. See "Installing a Hard-Drive Blank." CAUTION: To maintain proper system cooling, all empty hard-drive bays must have drive blanks installed. 6 Install the front bezel. See "Installing the Front Bezel." Installing a Hot-Swap Hard Drive CAUTION: When installing a hard drive, ensure that the adjacent drives are fully installed. Inserting a hard-drive carrier and attempting to lock its handle next to a partially installed carrier can damage the partially installed carrier's shield spring and make it unusable. CAUTION: Ensure that your operating system supports hot-swap drive installation. See the documentation supplied with your operating system. 1 Remove the front bezel. See "Removing the Front Bezel." 2 If a drive blank is present in the bay, remove it. See "Installing a Hard- Drive Blank." Installing System Components 85