Dell PowerEdge T610 Hardware Owner's Manual - Page 103
Integrated Dell Remote Access Controller 6, iDRAC6 Enterprise Card Optional
View all Dell PowerEdge T610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
3 Locate the USB connector on the internal USB module and insert the USB memory key into the connector. See Figure 3-12. 4 Close the system. See "Closing the System." 5 Place the system upright and on its feet on a flat, stable surface. 6 Reattach any peripherals, then connect the system to the electrical outlet. 7 Turn on the system and attached peripherals. Integrated Dell Remote Access Controller 6 (iDRAC6) Enterprise Card (Optional) The optional iDRAC6 Enterprise card provides a set of advanced features for managing the system remotely. Installing the iDRAC6 Enterprise Card 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals. 2 Open the system. See "Opening the System." 3 Remove the expansion card stabilizer. See "Removing the Expansion Card Stabilizer." 4 Remove the cooling shroud. See "Removing the Cooling Shroud." 5 Remove the plastic filler plug for the iDRAC6 Enterprise port from the system back panel. See "Back-Panel Features and Indicators" for the port location. 6 Remove the VFlash SD card (if installed) from the iDRAC6 Enterprise card. See "VFlash Media (Optional)." 7 Install the iDRAC6 Enterprise card: a Angle the card so that the RJ-45 connector fits through the hole in the chassis for the iDRAC6 Enterprise port. See Figure 1-4 for the hole location. b Align the front edge of the card with the two front plastic retention standoffs near the iDRAC6 connector on the system board. See Figure 6-1 for the location of the connector. c Press the card down until it is fully seated. See Figure 3-13. Installing System Components 103