Dell PowerEdge T610 Hardware Owner's Manual - Page 99
Internal USB Module, Removing an Internal SD Flash Card, Removing the Internal USB Module
View all Dell PowerEdge T610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals. 2 Open the system. See "Opening the System." 3 Locate the SD card connector on the internal SD module and, with the label side facing up, insert the contact-pin end of the card into the slot. See Figure 3-11. NOTE: The slot is keyed to ensure correct insertion of the card. 4 Press the card into the card slot to lock it into place. 5 Close the system. See "Closing the System." 6 Place the system upright and on its feet on a flat, stable surface. 7 Reattach any peripherals, then connect the system to the electrical outlet. 8 Turn on the system and attached peripherals. Removing an Internal SD Flash Card 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System." 3 Locate the SD card slot in the internal SD module and press inward on the card to release it from the slot and remove the card. 4 Close the system. See "Closing the System." 5 Place the system upright and on its feet on a flat, stable surface. 6 Reattach any peripherals, then connect the system to the electrical outlet. 7 Turn on the system and attached peripherals. Internal USB Module Removing the Internal USB Module 1 Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet. 2 Open the system. See "Opening the System." 3 Remove the expansion card stabilizer. See "Removing the Expansion Card Stabilizer." Installing System Components 99